This is a very limited SPECIAL PURCHASE.
This is our "FF" Series. We bought out a TON of Fully hollow 3 1/2"" deep Jazz style bodies and necks to match. These are "In Production" factory products so they are assembled and ready for your final finishing. You'll need to do all the TLC stuff stuff- sanding, grain filling, final finishing. As you can see these were originally prepared for a glued in dovetail neck, so you'll need to hand fit a neck to fit this body- Will take some work but you are buying this for LESS than the cost of the wood alone.
This is a laminated maple body with arched top and back, unbound F Holes, triple body binding, cut for two humbuckers with solid maple center section. Ready for an offset tenon neck like our FF1000 neck. This is a smaller version of the "Joe Pass" style body. It is 19 1/2" long, 12" wide at the upper bout, 9 3/4" inches at the waist and 15 3/4" at the lower bout.
So, to build this guitar you have to earn it- but consider the result! WAY cheaper than a guitar kit and you'll have the opportunity to finish in good old fashioned lacquer and make your own great guitar.
These have a 1 3/4" wide offset tenon wide tenon- that fit our FF 1000 Series Necks. (With lots of hand fitting)
These are UNFINISHED and all have some marks from handling-and some factory dirt on them- so you'll want to sand them down to nice clean wood prior to finishing.